• 61 Posts
  • 59 Comments
Joined 1 year ago
cake
Cake day: June 16th, 2023

help-circle

















  • Did you follow some guide when replacing the nozzle and bowden tube?

    No, it’s pretty intuitive so I just did it.

    Did you hot tighten it when putting them back?

    Yep.

    What speed are you printing at, which you think is too slow? What’s your acceleration?

    I was printing a speed test, the inbuilt one from Orca Slicer. Starts with a huge, slow brim, then low speed 10 layers, then slightly faster 10 layers, repeat until it fails.