That is not how it is supposed to look, the end result should be at least a couple of inches wide.
That is not how it is supposed to look, the end result should be at least a couple of inches wide.
Maybe you don’t need to ‘fix’ your retraction settings?
If it looks good enough, why bother?
Wasn’t aware of the test (SuperSlicer user here), and found this.
The tower has multiple notches, each one corresponding to a different retraction length. By looking at the tower after printing, you can see how each retraction length affects the print quality.
So check your surface finish and select the retraction value with the best looks.
Gonna recommend this to all my co workers.
It is not vulnerable to Windows viruses.
:-)
Blowtorch will heat this up way too hot.
Try to get it to a high enough temperature to insert filament to do a cold pull and repeat…
Electrical heat gun (paint stripper) is hot enough. Gas based torches will change the stiffness of your material and you will regret it.
Thanks for this. Finamp looks really nice.