I figured there might be something like this that i hadn’t seen. I’ll look into it tomorrow, i get the feeling this would cause the inconsistency.
I figured there might be something like this that i hadn’t seen. I’ll look into it tomorrow, i get the feeling this would cause the inconsistency.
I have never bought an ender. I just happen to have one :P
Ah, thank you for the advice and the link!
The falling prints i think have issues in the same spots, there are relatively small patches around the print surface that don’t print very well, though they don’t seem to correspond to the bed leveling screws or anything. Now that i say that I’ll have to check that I’m using the mesh level correctly when i get home.
I’m still using a Bowden type extruder. The extruder itself is a generic aluminum one. My filament is run out of a sunlu dryer by the side of the machine.
I think i actually raised the jerk at one point to reduce the radius on corners, so i can bring that back down again and experiment with acceleration.
I have a glass bed and I’m using the tramming function with the mriscoc firmware to give me depth readings for each of the four screws, and I usually reign them in to about 0.04mm range. Parts close to each other tend to have similar but not the same results, and i think the patches are too small to be from bed leveling, usually only a couple centimeters.
I can redo esteps, i can see what you mean about the overextrusion. I only set my esteps to the number recommended by the manufacturer of my extruder, but i haven’t measured it myself yet, maybe that’s a bit silly of me. Though if that’s the problem then I’m still curious why it’s different in different areas.
I can check out acceleration too, i looked up what acceleration and jerk meant at one point but it didn’t make much sense to me at the time.
Common piracy W
If only i knew the truths 😞
They rounded it on the wrong axis
I may have found a phone for you. It’s called the unihertz tank 2
https://www.unihertz.com/products/tank-2
Comes with a few other really interesting features you don’t see on any other phone (like a goddamn laser projector?), though i think the processor is a little underpowered.
I wish thicker bezels were more common tbh. It’s annoying to swipe from the side of the screen when my case is in the way.
They were no more of a pain than fishing out a wireless holder, and they took up even less space. The reason people used wireless was because manufacturers stopped giving people the option to use wired. That being said, having a headphone jack still lets you use wireless.
And nobody actually uses wired for audio quality, they use it because they don’t have to charge their headphones and separate headphone case or deal with the health of another battery, they can connect and disconnect their audio devices faster and easier, they don’t have to pay for an extra wireless chip and dac in their headphones or a third battery and electronics in a case.
There’s actually quite a few good reasons to have the option available if you want it. I’d argue this is a “dress with no pockets” scenario, where everybody begrudgingly puts up with it because the manufacturers don’t give them an option.
Pretty much every single person i talk to about this thinks that removing the headphone jack was a stupid idea, and those who don’t think it’s stupid are indifferent anyway.
I’m waiting for a fairphone with a headphone jack and then hopping on that.
Wow, this is an incredible guide thanks for showing me